√在线天堂中文最新版网,97se亚洲综合色区,国产成人av免费网址,国产成人av在线影院无毒,成人做爰100部片

×

loudspeaker driver造句

例句與造句

  1. As of August 2014 the program's setup uses five loudspeaker drivers.
  2. From this point, connections are made to the loudspeaker drivers  usually through audio crossover networks.
  3. Intermodulation in loudspeaker drivers is, as with harmonic distortion, almost always larger than in most electronics.
  4. This is a measure of how well a power amplifier controls the undesired motion of a loudspeaker driver.
  5. The loudspeaker driver is sealed to the mat so that all acoustic output in one direction must pass through the mat.
  6. It's difficult to find loudspeaker driver in a sentence. 用loudspeaker driver造句挺難的
  7. Fostex's current product range includes digital multitrack recording equipment, loudspeaker drivers, studio monitors, microphones, and headphones.
  8. These are the physical parameters of a loudspeaker driver, as measured at small signal levels, used in the equivalent electrical circuit models.
  9. The graph above shows the impedance curve of a single loudspeaker driver in free-air ( unmounted in any type of enclosure ).
  10. Most hi-fi speaker systems and sound reinforcement system speaker cabinets combination of multiple loudspeaker drivers, each catering to a different frequency band.
  11. In 1950 Bozak was hired as a consultant by McIntosh Laboratory to develop a square loudspeaker driver unit but it was not an engineering success.
  12. As with all loudspeaker drivers, the magnets are usually made from Alnico, ceramic, or, to reduce weight on more expensive models, neodymium.
  13. There are three types of power handling in loudspeaker drivers, including woofers : thermal ( heat ), electrical ( both covered above ), and mechanical.
  14. Crossovers are used because most individual loudspeaker drivers are incapable of covering the entire audio spectrum from low frequencies to high frequencies with acceptable relative volume and absence of distortion.
  15. For conventional loudspeaker drivers, this essentially involves ensuring that the output impedance of the amplifier is close to zero and that the speaker wires are sufficiently short and have sufficiently large diameter.
  16. A resistive mat is placed in front of or directly behind the loudspeaker driver ( usually mounted on the rear deck of the car in order to use the trunk as an enclosure ).
  17. 更多例句:  下一頁

相鄰詞匯

  1. "loudspeaker cabinets"造句
  2. "loudspeaker cone"造句
  3. "loudspeaker control"造句
  4. "loudspeaker diaphragm"造句
  5. "loudspeaker directivity"造句
  6. "loudspeaker efficiency"造句
  7. "loudspeaker enclosure"造句
  8. "loudspeaker group"造句
  9. "loudspeaker horn"造句
  10. "loudspeaker housing"造句
桌面版繁體版English日本語

Copyright ? 2025 WordTech Co.